Archive for the ‘Uncategorized’ Category

Configuring Wi-fi connection with BSNL DataOne Broadband on a laptop with RHEL 4 and Huawei WA1003A DSL Router

July 15, 2006

I had installed Red Hat Enterprise Linux 4 (WS or Desktop) in HP nx6130 with onboard Intel Pro 2200BG Wireless Card. Rpm ipw2200-firmware (for HP nx6130) is required to be installed in your laptop and can be found at If you are using any other card, then firmware for that particular should be installed.

Start the network configuration fron System Settings -> Network. Add a New Device and then select Wireless Connection and press next, your card should be visible here (in my case it was “Intel Corporation PRO/Wireless 2200 BG (eth1)”. Select this card and press forward and in the SSID just enter WA1003A and then press forward. In the next, screen you need to put in the network settings. Select static IP address and give the IP Adddress with subnet mask and gateway as In the DNS setting, add the following two addresses and This is all you have to do in the laptop part.

Now you have to configure you Huawei WA1003A DSL router. Connect the LAN (CAT5) cable between the laptop (in the other ethernet(eth0) port) and router. Open the network configuration setting and give the IP Address to eth0 with subnet mask Save the configuration and activate the eth0 Open browser and enter as url and you will get Huawei Configurations page. Enter admin as user and admin as password. Goto Setup and click PVC0 link at the left hand corner. Change the connection type from Bridge to pppoe. You will get an option of username and password. Enter the user name and password you got from BSNL for accessing their DataOne service. Press Apply and goto Advanced and then Tools and press Save All and then press Restart. Ping the address from the laptop after deactivating your eth0 connection and disconnecting your LAN cable. If you get a reply then your Wi-fi connection in the laptop is ready. Start browsing and ENJOY!This procedure may also work for Fedora but I haven’t tested it yet.